How Do You Use the Curve Tool Openoffice Draw

Send away drawing of a Bézier curve

	Open the Curve toolbar by clicking connected the small black triangle of the symbolization on the Draw toolbar. Click on the Bender icon . The mouse cursor changes to .
	Click on the set forth level of the curve and keep the mouse release pressed (starting and end points are shown here in the figures as snap points).
	Drag out the sneak to approximately the position of your first control point. Information technology does not matter if this is not exactly right as you can move the control point location subsequently. If you hold the Shift winder down while dragging, the control direct bequeath lie connected a 45 level grid.
	Release the black eye button and move the mouse to the position of the end stage of the curve. You hind end see that the line of the curve follows the movement of the mouse. Double-click at the goal position.
	Wind up point musical mode with the [[Figure:]] icon from the Draw toolbar. At the end of the curve you will see not only the end point but also an associated controller point, the round handle. Hovering the mouse cursor over this stop you can see that the cursor shape changes to record that you are in redact mode of a control point.
	If necessary, straight off you can drag the contain point to its correct situatio.

Drawing a succession of Bézier curves

Several lines operating room Bézier curves can be linked put together. The single parts are referred to as segments. Technically such a chronological sequence of Bézier curves and lines is legendary A a way.

Begin the drawing as with a lancelike Bézier curve. At the terminate position of the first segment, end not with a equivocal-click but rather with incomparable of the chase methods:

• Click on the end pointedness of the primary segment but do not keep the mouse button pressed. In this means you produce a cut charge which is some a control point for the first section and a control point for the secondly segment. This ascendancy point lies however on the actual curve peak and thus does non influence the direction of the following curve segment. Move the mouse to the end berth of the second segment. This section appears to be a straight line merely is in fact a Bézier curve. Either double-click to finish the wind or repeat the in a higher place function to add successive segments.

Oregon

• Go back and click once on the end point of the first segment and keep the mouse release ironed. Now you can, as at the start but immediately for the second section, place the control point. Unblock the sneak away clitoris at the position of the control point and move the mouse to the destruction position of the irregular segment. The twist follows the line of movement of the mouse.

You can either terminate the draftsmanship here with a double-chink or continue and link in further segments.

To generate a closed curve, select the curve and click on the Scalelike Bézier icon [[Image:]] on the Edit Points toolbar, or from the context menu take the option Close object.

How Do You Use the Curve Tool Openoffice Draw

Source: https://wiki.openoffice.org/wiki/Documentation/OOoAuthors_User_Manual/Draw_Guide/Drawing_B%C3%A9zier_curves#:~:text=Click%20on%20the%20start%20point,the%20control%20point%20location%20later.

Share this post